Sorry for my bad explanation – I’m not familiar with the board and the way the bios looks Be Social with eTeknix. When it was in your old machine and working doesn’t means that failure cannot happens during the stage of transferring. That said, it is possible and I will be able to hit the maximum performance of this DAS. I did try to load from the old IDE to see if it would boot up on the new system and it did the same blue screen. It does require extra adapters and hardware, so it might be cheaper to find a unit that has native support for it. You could still get yourself an aftermarket USB Type-C to Type-C cable should you want to use the new reversible connector at both ends.
|Date Added:||22 March 2012|
|File Size:||39.77 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The following error or errors occurred while this message: That worked like a charm and the two drive adapters slid right into the unit.
The included cable is a Type-C to Type-A cable. I disabled the reboot on the advanced system pref. While the unit only supports 3. So yea, it is possible to install 2. As far as the priority goes I have: The ATTO Disk Benchmark performance measurement tool allows to test your storage systems performance with various transfer sizes and test lengths for reads and writes.
The old system that I had got tossed. The unit itself features four large rubber feet which will keep the unit where you place it. From there you can find clues of what’s wrong. Click here to cancel reply. The device itself is made from an SECC body with an aluminium finish. Anvil’s Storage Utilities 7.
On the rear is the power connector as well as the RAID selection. Is there something I have to do within windows to get this going or do you think it is with the Bios? Ms-71033 drives will be tested in all available drive modes.
Adding IDE HDD to a new system with SATA Installed
The Bios shows that it is there but when the system boots it will go fine until the end of the boot sequence where it looks like a blue screen then reboots very quickly.
The synthetic tests determine the sequential and random read and write performance of the SSD. Which IDE port you plug into? Home Help Search Login Register.
Speak Your Mind Tell us what you’re thinking The brushed aluminium door gives the unit a great look. All trademarks used are properties of their respective owners. It does require extra adapters and hardware, so it might be cheaper to find a unit that has native support for it. I disabled mms-7103 RAID option and it still went to a blue screen and rebooted.
The simple design is important for a storage device, at least in my opinion. Both are hardware RAID units that utilise two 2. The drive bays are built for tool-less and tray-less installation.
MSI 661FM3-V MS-7103 MS7103 MS 7103 Ver 1 Motherboard 775 AGP VGA 2x PCI LAN USB
Please login or register. That said, it is possible and I will be able to hit the maximum performance of this DAS.
This will help narrow down the problem mx-7103. The app has unique capabilities to assess the performance of the processor, system memory, and disk drives and is compatible with most Microsoft Windows operating systems.
The second controller is the ASM which is a passive 10Gbps signal switch. Change that mx-7103 and come back later But if there is a specific test that you want me to run. When it was in your old machine and working doesn’t means that failure cannot happens during the stage of transferring.